DS 3: Lighting and visibility / DS MATRIX LED VISION
DS 3 2016-2024 Owners Manual
For more information,
refer to the General
recommendations for automatic lighting
systems.
Available only on versions equipped with Full LED
headlamps with Matrix Beam function.
This system automatically adapts the main
beam according to the driving conditions, so that
optimum illumination is maintained for the driver,
without causing a nuisance to other road users.
The driver remains
responsible for the
vehicle's lighting, its correct use in the
prevailing light, visibility and traffic conditions,
and for compliance with driving and vehicle
regulations.
The
system is active from 25 mph
(40 km/h) and deactivates below 12 mph
(20 km/h).
If the situation requires a change of headlamp
beam, the driver can take over at any time.
Switch the headlamps manually between
dipped and main beam to pause the function...
Operation
Using a camera, the system detects the driving
conditions (brightess, lights from oncoming or
followed vehicles, road turns) and adapts the
beams of the main headlamps accordingly...
Other information:
Switching on the ignition without starting the engine
With the electronic key in the passenger
compartment, pressing the "START/STOP" button,
without depressing any of the pedals, allows the
ignition to be switched on without starting the
engine.
Press this button again to switch off the
ignition and allow the vehicle to be locked...
A message is displayed on the instrument panel
when the battery needs changing.
Battery type: CR2032/3 volts.
Unclip the cover by inserting a small
screwdriver in the slot and lift the cover.
Remove the flat battery from its housing.
Put the new battery in place, respecting the
polarity...