DS 3: Lighting and visibility / Daytime running lamps / Sidelamps
DS 3 2016-2026 Owners Manual
The front and rear lamps light up automatically
when the engine starts.
They provide the following functions:
- Daytime running lamps (lighting control stalk in
the "AUTO" position with adequate light level).
- Sidelamps (lighting control stalk in the "AUTO"
position with low light levels or "Sidelamps only”
or "Dipped/main beam headlamps").
The
LEDs are brighter when operating as
daytime running lamps.
It only works if the dipped or
main beam
headlamps are on.
Rotate the ring forwards/backwards to turn
it on/off.
When the lighting is switched off automatically
("AUTO" position) the foglamp and the sidelamps
remain on...
Left or right: lower or raise the lighting control
stalk, beyond the point of resistance.
If
you keep the direction indicators on for
more than 20 seconds, the volume of the
audible signal will increase if the speed is
above 50 mph (80 km/h)...
Other information:
Unless otherwise indicated, check these
components in accordance with the
manufacturer's service schedule and according to
your engine.
Otherwise, have them checked by a dealer or a
qualified workshop.
Only use products
recommended by the
Manufacturer or products of equivalent
quality and specification...
Before changing a fuse:
Identify the cause of the fault and fix it.
Switch off all power consumption.
Immobilise the vehicle and switch off the
ignition.
Identify the defective fuse using the current
allocation tables and diagrams.
To replace a fuse, it is essential to:
Use the special tweezers to extract the fuse
from its housing and check the condition of its
filament...