DS 3: Doors / Retractable handles
DS 3 2016-2025 Owners Manual
The doors are equipped with handles that unfold
and retract automatically depending on the
vehicle state:
- When unlocking the vehicle, the handles unfold
to allow access to the vehicle.
- When the vehicle is locked, the handles retract.

- It is possible to manually unfold the handles at
any time by pressing on them.
Once unfolded, the handles retract automatically
after 3 minutes without the vehicle being locked.
Depending on version, pressing on the handles
also locks/unlocks the vehicle, if the electronic
key is detected.
For more information on Proximity Keyless Entry
and Start, refer to the corresponding section.
In the event of a battery
failure or system
malfunction, manually unfold the driver’s
handle by pressing on it up to the point of
resistance. Then pull the handle to access the
lock and follow the back-up procedures.
For more information on the Back-up
procedures, refer to the corresponding section.
Too frequent presses on
the handle up to
the point of resistance may damage its
mechanism.
In case of frost, press
the handle to
release it.
From inside the vehicle, it is possible to unfold the
handles:
- by opening a door.
- by pressing the central locking button once
when the vehicle is locked or twice when
unlocked.
When driving, the handles automatically retract
once the vehicle speed exceeds 2 mph (3 km/h).
From outside
Unlock your vehicle to unfold the door handles.
Pull the handle.
When selective unlocking
is activated,
only the driver door's handle will unfold
and only the driver's door can be opened...
Other information:
Operation
Using a camera, the system detects the driving
conditions (brightess, lights from oncoming or
followed vehicles, road turns) and adapts the
beams of the main headlamps accordingly.
The modules that make up the main beams
switch on and off gradually, segment by segment,
depending on the driving conditions detected:
Followed vehicle
When approaching a vehicle from behind, only
those..
It is recommended that the AdBlue® be topped up
as soon as the first alert is issued indicating that
the reserve level has been reached.
For the correct operation
of the SCR
system:
Use only AdBlue® fluid that meets the ISO
22241 standard.
Never transfer AdBlue® to another container
as it would lose its purity.
Never dilute AdBlue® with water.
You can obtain AdBlue® from a deale..