DS 3: Back-up procedures / Reinitialising the remote control
DS 3 2016-2026 Owners Manual
Following replacement of the battery or in the
event of a fault, it may be necessary to reinitialise
the remote control.

- Press the handle until the point of resistance
to unfold it and access the lock.
- Insert the mechanical key (incorporated into
the remote control) into the lock to open the
vehicle.
- Place the electronic key against the back-up
reader on the steering column and hold it there
until the ignition is switched on.
- With a manual gearbox, place the gear lever in
neutral then fully depress the clutch pedal.
- With an automatic gearbox or drive selector,
while in mode P, depress the brake pedal.
- Switch on the ignition by pressing the "START/
STOP" button.
If the fault persists after reinitialisation, contact
a dealer or a qualified workshop without delay.
A message is displayed on the instrument panel
when the battery needs changing.
Battery type: CR2032/3 volts.
Unclip the cover by inserting a small
screwdriver in the slot and lift the cover...
Other information:
For more information,
refer to the General
recommendations on the use of driving
and manoeuvring aids.
The system corrects the vehicle's trajectory by
alerting the driver as soon as it detects a risk of
involuntary lane departure or crossing of a verge
or hard shoulder (depending on version).
To do this, the system uses a camera, placed on
the upper part of the windscreen, identifying the ..
Voice control:
This control is located on the steering
wheel or at the end of the lighting control stalk
(depending on equipment).
Short press, system voice control.
Long press, voice commands from smartphone or
CarPlay®, Android Auto via the system.
Increase volume.
Decrease volume.
Mute by pressing the volume increase and
decrease buttons simultaneously (depending on
equipment).
Restore..