DS 3: Reversing camera / Principle of operation
DS 3 2016-2026 Owners Manual

Using the rear camera, the vehicle's close
surroundings are recorded during manoeuvres at
low speed.
An image from above your vehicle in its close
surroundings is reconstructed (represented
between the brackets) in real time and as the
manoeuvre progresses.
It facilitates the alignment of your vehicle when
parking and allows obstacles close to the vehicle
to be seen. It is automatically deleted if the
vehicle remains stationary for too long.
For more information,
refer to the General
recommendations on the use of driving
and manoeuvring aids.
As soon as reverse gear is engaged with the
engine running, this system displays views of your
vehicle’s close surroundings on the touch screen
using a camera located at the rear of the vehicle...
Rear view
To activate the camera located on the tailgate,
engage reverse gear and do not exceed a speed of
6 mph (10 km/h).
The system is deactivated:
Automatically, at speeds above approximately
12 mph (20 km/h),
When changing out of reverse gear...
Other information:
Before operating the wipers in wintry
conditions, clear any snow, ice or frost
from the windscreen and around the wiper
arms and blades.
Do not operate the wipers
on a dry
windscreen. In extremely hot or cold
weather, check that the wiper blades are not
stuck to the windscreen before operating the
wipers...
To access the rear screw thread:
Unclip the cover by pressing at its left-hand
section.
Pull the cover downwards.
To tow:
Screw the towing eye in fully.
Install the towbar.
Switch on the hazard warning lamps on both
vehicles.
Move off gently, drive slowly and only for a
short distance...